CLI Reference Guide-R01

Chapter 1 | Initial Switch Configuration
Installing a Port License File
– 60 –
Installing a Port License File
The switch ports are disabled by default. The ports will only function when a port
license is obtained from Edgecore and installed on the switch.
To verify whether or not a port license is installed on the switch, enter the show
interfaces brief command from the console port. If a port Status displays “License,”
then you need to obtain and install a port license for those ports. Note that a trial
license limits the number of usable ports, whereas a valid license provides full
access to all ports.
Console#show interfaces brief
Interface Name Status PVID Pri Speed/Duplex Type Trunk
--------- --------------- -------- ---- --- ------------- ------------ -----
Eth 1/ 1 Down 1 0 Auto 1000BASE-T None
Eth 1/ 2 License 1 0 Auto 1000BASE-T None
Eth 1/ 3 License 1 0 Auto 1000BASE-T None
Eth 1/ 4 License 1 0 Auto 1000BASE-T None
Eth 1/ 5 License 1 0 Auto 1000BASE-T None
Eth 1/ 6 License 1 0 Auto 1000BASE-T None
.
.
.
Console#
To order a license, you must provide the following information to Edgecore:
◆ Switch model number (for example, ECS4130-28T)
◆ System MAC address. Enter the show system command from the console port
to display this information.
Console#show system
System Description : ECS4130-28T-AC
System OID String : 1.3.6.1.4.1.259.10.1.53.102
System Information
System Up Time : 0 days, 3 hours, 46 minutes, and 34.96 seconds
System Name :
System Location :
System Contact :
MAC Address (Unit 1) : 90-3C-B3-8C-44-B2
Web Server : Enabled
Web Server Port : 80
Web Secure Server : Enabled
Web Secure Server Port : 443
Telnet Server : Enabled
Telnet Server Port : 23
Jumbo Frame : Disabled
To install a license, first verify that the switch is configured with a valid IP address
(see “Setting an IP Address” on page 49).