CLI Reference Guide-R01

Chapter 4 | System Management Commands
Switch Clustering
– 173 –
cluster member This command configures a Candidate switch as a cluster Member. Use the no form
to remove a Member switch from the cluster.
Syntax
cluster member mac-address mac-address id member-id
no cluster member id member-id
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch. (Range: 1-36)
Default Setting
No Members
Command Mode
Global Configuration
Command Usage
◆ The maximum number of cluster Members is 36.
◆ The maximum number of cluster Candidates is 100.
Example
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
rcommand This command provides access to a cluster Member CLI for configuration.
Syntax
rcommand id member-id
member-id - The ID number of the Member switch. (Range: 1-36)
Command Mode
Privileged Exec
Command Usage
◆ This command only operates through a Telnet connection to the Member
switch. Managing cluster Members using the local console CLI on the
Commander is not supported.
◆ There is no need to enter the username and password for access to the Member
switch CLI.