Web Management Guide-R01

Table Of Contents
Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 59 –
Configure Interface Sets the trust mode for an interface 356
Show Information Displays the DHCP Snooping binding information 357
DHCP Snooping6 351
Configure Global Enables DHCPv6 snooping globally, MAC-address verification,
information option; and sets the information policy
353
Configure VLAN Enables DHCPv6 snooping on a VLAN 355
Configure Interface Sets the trust mode for an interface 356
Show Information Displays the DHCPv6 Snooping binding information 357
ND Snooping 367
Configure Global Enables ND Snooping globally on the switch 368
Configure VLAN Enables ND Snooping on a VLAN or range of VLANs 370
Configure Interface Sets the trust mode for an interface 371
Show Information Displays the ND Snooping binding and prefix information 372
IP Source Guard Filters IP traffic based on static entries in the IP Source Guard table, or
dynamic entries in the DHCP Snooping table
373
General Enables IP source guard and selects filter type per port 373
Static Binding 376
Configure ACL Table 376
Add Adds static addresses to the source guard ACL binding table 376
Show Shows static addresses in the source guard ACL binding table 376
Configure MAC Table 376
Add Adds static addresses to the source guard MAC address binding table 376
Show Shows static addresses in the source guard MAC address binding table 376
Dynamic Binding Displays the source-guard binding table for a selected interface 378
IPv6 Source Guard Filters IPv6 traffic based on static entries in the IP Source Guard table, or
dynamic entries in the DHCP Snooping table
379
Port Configuration Enables IPv6 source guard and selects filter type per port 379
Static Binding 382
Add Adds a static addresses to the source-guard binding table 382
Show Shows static addresses in the source-guard binding table 382
Dynamic Binding Displays the source-guard binding table for a selected interface 384
ARP Inspection 385
Configure General Enables inspection globally, configures validation of additional address
components, and sets the log rate for packet inspection
386
Configure VLAN Enables ARP inspection on specified VLANs 388
Table 4: Switch Main Menu (Continued)
Menu Description Page