Web Management Guide-R01

Chapter 13 | Basic Administration Protocols
Ethernet Ring Protection Switching
– 489 –
Web Interface
To create an ERPS instance:
1. Click Administration, ERPS.
2. Select Configure Instance from the Step list.
3. Select Add from the Action list.
4. Enter a name and optional identifier for the instance.
5. Click Apply.
Figure 315: Creating an ERPS Instance
To configure the ERPS parameters for an instance:
1. Click Administration, ERPS.
2. Select Configure Instance from the Step list.
3. Select Configure Details from the Action list.
4. Configure the ERPS instance parameters for this node. Note that spanning tree
protocol cannot be configured on the ring ports, nor can these ports be
members of a static or dynamic trunk. And the control VLAN must be unique
for each ring. Adjust the protocol timers as required. The RPL owner must be set
on one of the rings. And the administrative status enabled once all of the other
settings have been entered.
5. Click Apply.