CLI Reference Guide-R01

Chapter 28 | IP Routing Commands
Global Routing Configuration
– 873 –
changes occur in the network, the routing table is updated, and those changes
are immediately reflected in the FIB.
The FIB is distinct from the routing table (or, Routing Information Base), which
holds all routing information received from routing peers. The forwarding
information base contains unique paths only. It does not contain any secondary
paths. A FIB entry consists of the minimum amount of information necessary to
make a forwarding decision on a particular packet. The typical components
within a forwarding information base entry are a network prefix, a router port
identifier, and next hop information.
◆ This command only displays routes which are currently accessible for
forwarding. The router must be able to directly reach the next hop, so the VLAN
interface associated with any dynamic or static route entry must be up.
Example
In the following example, note that the last entry displays both the distance and
metric for this route.
Console#show ipv6 route
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
C ::1/128, lo0
? FE80::/64, VLAN1 inactive
C FE80::/64, VLAN1
? FF00::/8, VLAN1 inactive
O IA 3FFF:1::/32 [110/3]
via FE80::204:FF:FE05:6, VLAN1
Console#
ECMP Commands
maximum-paths This command sets the maximum number of paths allowed. Use the no form to
restore the default settings.
Syntax
maximum-paths path-count
no maximum-paths
path-count - The maximum number of equal-cost paths to the same
destination that can be installed in the routing table. (Range: 1-8)
Command Mode
Global Configuration