CLI Reference Guide-R01

Table Of Contents
Chapter 28
| Domain Name Service Commands
DNS Commands
– 773 –
name - Name of an IPv4 host. (Range: 1-127 characters)
address - Corresponding IPv4 address.
Default Setting
No static entries
Command Mode
Global Configuration
Command Usage
Use the no ip host command to clear static entries.
Example
This example maps an IPv4 address to a host name.
Console(config)#ip host rd5 192.168.1.55
Console(config)#end
Console#show hosts
No. Flag Type IP Address TTL Domain
---- ---- ------- -------------------- ----- ------------------------------
0 2 Address 192.168.1.55 rd5
Console#
ip name-server This command specifies the address of one or more domain name servers to use for
name-to-address resolution. Use the no form to remove a name server from this
list.
Syntax
[no] ip name-server server-address1 [server-address2
server-address6]
server-address1 - IPv4 or IPv6 address of domain-name server.
server-address2server-address6 - IPv4 or IPv6 address of additional
domain-name servers.
Default Setting
None
Command Mode
Global Configuration
Command Usage
The listed name servers are queried in the specified sequence until a response is
received, or the end of the list is reached with no response.