CLI Reference Guide-R01

Chapter 12 | Link Aggregation Commands
– 430 –
Example
Console(config)#port-channel load-balance dst-ip
Console(config)#
channel-group This command adds a port to a trunk. Use the no form to remove a port from a
trunk.
Syntax
channel-group channel-id
no channel-group
channel-id - Trunk index (Range: 1-28)
Default Setting
The current port is not a member of any trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆ When configuring static trunks, the switches must comply with the Cisco
EtherChannel standard.
◆ Use no channel-group to remove a port group from a trunk.
◆ Use no interface port-channel to remove a trunk from the switch.
Example
The following example creates trunk 1 and then adds port 10:
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/10
Console(config-if)#channel-group 1
Console(config-if)#
Dynamic Configuration Commands
lacp This command enables 802.3ad Link Aggregation Control Protocol (LACP) for the
current interface. Use the no form to disable it.
Syntax
[no] lacp