Web Management Guide-R04

Chapter 13 | Basic Administration Protocols
Link Layer Discovery Protocol
– 422 –
To show the physical location of the attached device:
1. Click Administration, LLDP.
2. Select Configure Interface from the Step list.
3. Select Show CA-Type from the Action list.
4. Select an interface from the Port or Trunk list.
Figure 261: Showing the Civic Address for an LLDP Interface
To modify the physical location of the attached device:
1. Click Administration, LLDP.
2. Select Configure Interface from the Step list.
3. Select Modify CA-Type from the Action list.
4. Select an interface from the Port or Trunk list.
5. Specify the CA-Value as required.
6. Click Apply.
Figure 262: Configuring the Civic Address for an LLDP Interface