Web Management Guide-R04

Figures
– 29 –
Figure 345: Configuring Detailed Settings for Maintenance Associations 533
Figure 346: Configuring Maintenance End Points 535
Figure 347: Showing Maintenance End Points 535
Figure 348: Configuring Remote Maintenance End Points 537
Figure 349: Showing Remote Maintenance End Points 537
Figure 350: Transmitting Link Trace Messages 539
Figure 351: Transmitting Loopback Messages 540
Figure 352: Transmitting Delay-Measure Messages 542
Figure 353: Showing Information on Local MEPs 543
Figure 354: Showing Detailed Information on Local MEPs 545
Figure 355: Showing Information on Local MIPs 546
Figure 356: Showing Information on Remote MEPs 547
Figure 357: Showing Detailed Information on Remote MEPs 549
Figure 358: Showing the Link Trace Cache 551
Figure 359: Showing Settings for the Fault Notification Generator 552
Figure 360: Showing Continuity Check Errors 553
Figure 361: Enabling OAM for Local Ports 556
Figure 362: Displaying Statistics for OAM Messages 557
Figure 363: Displaying the OAM Event Log 558
Figure 364: Displaying Status of Remote Interfaces 559
Figure 365: Running a Remote Loop Back Test 561
Figure 366: Displaying the Results of Remote Loop Back Testing 562
Figure 367: Configuring UDLD Protocol Intervals 564
Figure 368: Configuring UDLD Interface Settings 566
Figure 369: Displaying UDLD Neighbor Information 567
Figure 370: Configuring Global Settings for LBD 569
Figure 371: Configuring Interface Settings for LBD 570
Figure 372: Configuring the Smart Pair Global Settings (Adding a Smart Pair) 572
Figure 373: Configuring Interfaces for a Smart Pair 573
Figure 374: Displaying the Smart Pair IDs. 573
Figure 375: Displaying Port Members of a Smart Pair 574
Figure 376: Multicast Filtering Concept 576
Figure 377: Configuring General Settings for IGMP Snooping 582
Figure 378: Configuring a Static Interface for a Multicast Router 583
Figure 379: Showing Static Interfaces Attached a Multicast Router 584