Web Management Guide-R04
Table Of Contents
- How to Use This Guide
- Contents
- Figures
- Tables
- Getting Started
- Web Configuration
- Using the Web Interface
- Basic Management Tasks
- Displaying System Information
- Displaying Hardware/Software Versions
- Configuring Support for Jumbo Frames
- Displaying Bridge Extension Capabilities
- Managing System Files
- Setting the System Clock
- Configuring the Console Port
- Configuring Telnet Settings
- Displaying CPU Utilization
- Configuring CPU Guard
- Displaying Memory Utilization
- Resetting the System
- Interface Configuration
- VLAN Configuration
- Address Table Settings
- Spanning Tree Algorithm
- Congestion Control
- Class of Service
- Layer 2 Queue Settings
- Layer 3/4 Priority Settings
- Setting Priority Processing to IP Precedence/DSCP or CoS
- Mapping Ingress DSCP Values to Internal DSCP Values
- Mapping CoS Priorities to Internal DSCP Values
- Mapping Internal DSCP Values to Egress CoS Values
- Mapping IP Precedence Values to Internal DSCP Values
- Mapping IP Port Priority to Internal DSCP Values
- Quality of Service
- VoIP Traffic Configuration
- Security Measures
- AAA Authentication, Authorization and Accounting
- Configuring User Accounts
- Web Authentication
- Network Access (MAC Address Authentication)
- Configuring HTTPS
- Configuring the Secure Shell
- Access Control Lists
- Filtering IP Addresses for Management Access
- Configuring Port Security
- Configuring 802.1X Port Authentication
- DoS Protection
- DHCPv4 Snooping
- DHCPv6 Snooping
- IPv4 Source Guard
- IPv6 Source Guard
- ARP Inspection
- Application Filter
- Basic Administration Protocols
- Configuring Event Logging
- Link Layer Discovery Protocol
- Simple Network Management Protocol
- Configuring Global Settings for SNMP
- Setting Community Access Strings
- Setting the Local Engine ID
- Specifying a Remote Engine ID
- Setting SNMPv3 Views
- Configuring SNMPv3 Groups
- Configuring Local SNMPv3 Users
- Configuring Remote SNMPv3 Users
- Specifying Trap Managers
- Creating SNMP Notification Logs
- Showing SNMP Statistics
- Remote Monitoring
- Switch Clustering
- Setting a Time Range
- Ethernet Ring Protection Switching
- OAM Configuration
- Connectivity Fault Management
- Configuring Global Settings for CFM
- Configuring Interfaces for CFM
- Configuring CFM Maintenance Domains
- Configuring CFM Maintenance Associations
- Configuring Maintenance End Points
- Configuring Remote Maintenance End Points
- Transmitting Link Trace Messages
- Transmitting Loop Back Messages
- Transmitting Delay-Measure Requests
- Displaying Local MEPs
- Displaying Details for Local MEPs
- Displaying Local MIPs
- Displaying Remote MEPs
- Displaying Details for Remote MEPs
- Displaying the Link Trace Cache
- Displaying Fault Notification Settings
- Displaying Continuity Check Errors
- OAM Configuration
- UDLD Configuration
- LBD Configuration
- Smart Pair Configuration
- Multicast Filtering
- Overview
- Layer 2 IGMP (Snooping and Query for IPv4)
- Configuring IGMP Snooping and Query Parameters
- Specifying Static Interfaces for a Multicast Router
- Assigning Interfaces to Multicast Services
- Setting IGMP Snooping Status per Interface
- Filtering IGMP Query Packets and Multicast Data
- Displaying Multicast Groups Discovered by IGMP Snooping
- Displaying IGMP Snooping Statistics
- Filtering and Throttling IGMP Groups
- MLD Snooping (Snooping and Query for IPv6)
- Multicast VLAN Registration for IPv4
- Multicast VLAN Registration for IPv6
- Basic IP Functions
- IP Configuration
- General IP Routing
- IP Services
- Appendices
- Glossary
Chapter 4
| Interface Configuration
Showing Port or Trunk Statistics
– 121 –
Deferred Transmissions A count of frames for which the first transmission attempt on a
particular interface is delayed because the medium was busy.
Frames Too Long A count of frames received on a particular interface that exceed the
maximum permitted frame size.
Symbol Errors A count of the times there was an invalid data symbol when a valid
carrier was present.
Alignment Errors The number of alignment errors (missynchronized data packets).
FCS Errors A count of frames received on a particular interface that are an integral
number of octets in length but do not pass the FCS check. This count
does not include frames received with frame-too-long or frame-too-
short error.
SQE Test Errors A count of times that the SQE TEST ERROR message is generated by the
PLS sublayer for a particular interface.
Carrier Sense Errors The number of times that the carrier sense condition was lost or never
asserted when attempting to transmit a frame.
Internal MAC Receive Errors A count of frames for which reception on a particular interface fails due
to an internal MAC sublayer receive error.
Internal MAC Transmit
Errors
A count of frames for which transmission on a particular interface fails
due to an internal MAC sublayer transmit error.
Pause Frames Output A count of MAC control frames transmitted on this interface with an
opcode indicating the pause operation.
RMON Statistics
Drop Events The total number of events in which packets were dropped due to lack
of resources.
Jabbers The total number of frames received that were longer than 1518 octets
(excluding framing bits, but including FCS octets), and had either an
FCS or alignment error.
Fragments The total number of frames received that were less than 64 octets in
length (excluding framing bits, but including FCS octets) and had either
an FCS or alignment error.
Collisions The best estimate of the total number of collisions on this Ethernet
segment.
Received Octets Total number of octets of data received on the network. This statistic
can be used as a reasonable indication of Ethernet utilization.
Received Packets The total number of packets (bad, broadcast and multicast) received.
Broadcast Packets The total number of good packets received that were directed to the
broadcast address. Note that this does not include multicast packets.
Multicast Packets The total number of good packets received that were directed to this
multicast address.
Undersize Packets The total number of packets received that were less than 64 octets long
(excluding framing bits, but including FCS octets) and were otherwise
well formed.
Oversize Packets The total number of packets received that were longer than 1518 octets
(excluding framing bits, but including FCS octets) and were otherwise
well formed.
Table 6: Port Statistics (Continued)
Parameter Description