ECS4110-52T_Management Guide

C HAPTER 40 | Multicast Filtering Commands
MVR for IPv6
– 1309 –
mvr6
robustness-value
This command configures the expected packet loss, and thereby the
number of times to generate report and group-specific queries. Use the no
form to restore the default setting.
SYNTAX
mvr6 robustness-value value
no mvr6 robustness-value
value - The robustness used for all interfaces. (Range: 1-10)
DEFAULT SETTING
2
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ This command sets the number of times report messages are sent
upstream when changes are learned about downstream groups, and
the number of times group-specific queries are sent to downstream
receiver ports.
◆ This command only takes effect when MVR6 proxy switching is enabled.
EXAMPLE
Console(config)#mvr6 robustness-value 5
Console(config)#
RELATED COMMANDS
mvr6 proxy-switching (1307)
mvr6
source-port-mode
dynamic
This command configures the switch to only forward multicast streams
which the source port has dynamcially joined. Use the no form to restore
the default setting.
SYNTAX
[no] mvr6 source-port-mode dynamic
DEFAULT SETTING
Forwards all multicast streams which have been specified in a profile and
bound to a domain.
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ By default, the switch forwards any multicast streams within the
address range set by a profile, and bound to a domain. The multicast