ECS4110-52T_Management Guide

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 117 –
Show Shows list of configured ERPS rings, status, and settings 500
Configure Details Configures ring parameters 500
Configure Operation Blocks a ring port using Forced Switch or Manual Switch commands 516
CFM Connectivity Fault Management 520
Configure Global Configures global settings, including administrative status, cross-
check start delay, link trace, and SNMP traps
523
Configure Interface Configures administrative status on an interface 527
Configure MD Configure Maintenance Domains 527
Add Defines a portion of the network for which connectivity faults can
be managed, identified by an MD index, maintenance level, and
the MIP creation method
527
Configure Details Configures the archive hold time and fault notification settings 527
Show Shows list of configured maintenance domains 527
Configure MA Configure Maintenance Associations 532
Add Defines a unique CFM service instance, identified by its parent MD,
the MA index, the VLAN assigned to the MA, and the MIP creation
method
532
Configure Details Configures detailed settings, including continuity check status and
interval level, cross-check status, and alarm indication signal
parameters
532
Show Shows list of configured maintenance associations 532
Configure MEP Configures Maintenance End Points 537
Add Configures MEPs at the domain boundary to provide management
access for each maintenance association
537
Show Shows list of configured maintenance end points 537
Configure Remote MEP Configures Remote Maintenance End Points 538
Add Configures a static list of remote MEPs for comparison against
the MEPs learned through continuity check messages
538
Show Shows list of configured remote maintenance end points 538
Transmit Link Trace Sends link trace messages to isolate connectivity faults by
tracing the path through a network to the designated target node
540
Transmit Loopback Sends loopback messages to isolate connectivity faults by
requesting a target node to echo the message back to the source
542
Transmit Delay Measure Sends periodic delay-measure requests to a specified MEP within a
maintenance association
544
Show Information
Show Local MEP Shows the MEPs configured on this device 546
Show Local MEP Details Displays detailed CFM information about a specified local MEP in
the continuity check database
547
Show Local MIP Shows the MIPs on this device discovered by the CFM protocol 548
Show Remote MEP Shows MEPs located on other devices which have been discovered
through continuity check messages, or statically configured in the
MEP database
549
Table 6: Switch Main Menu (Continued)
Menu Description Page