ECS4110-52T_Management Guide

C HAPTER 29 | Power over Ethernet Commands
– 1037 –
DEFAULT SETTING
ECS4110-28P: 390000 milliwatts
ECS4110-52P: 400000 milliwatts
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ Setting a maximum power budget for the switch enables power to be
centrally managed, preventing overload conditions at the power source.
◆ If the power demand from devices connected to the switch exceeds the
power budget setting, the switch uses port power priority settings to
limit the supplied power.
EXAMPLE
Console(config)#power mainpower maximum allocation 180
Console(config)#
RELATED COMMANDS
power inline priority (1039)
power inline This command instructs the switch to automatically detect if a PoE-
compliant device is connected to the specified port, and turn power on or
off accordingly. Use the no form to turn off power for a port, or the no
form with the time-range keyword to remove the time range settings.
SYNTAX
power inline [time-range time-range-name]
no power inline [time-range]
time-range-name - Name of a time-range during which PoE is
supplied to the attached device. (Range: 1-30 characters)
DEFAULT SETTING
Detection is enabled for PoE-compliant devices.
COMMAND MODE
Interface Configuration (Ethernet ports 1-24/48)
COMMAND USAGE
◆ The switch only provides power to the Gigabit Ethernet copper-media
ports.
◆ When detection is enabled for PoE-compliant devices, power is
automatically supplied when a device is detected on the port, providing
that the power demanded does not exceed the port’s power budget or
the switch’s power budget.