ECS4110-52T_Management Guide

C HAPTER 27 | Interface Commands
Transceiver Threshold Configuration
– 1012 –
threshold-value – The power threshold of the received signal.
(Range: -4000 - 820 in units of 0.01 dBm)
DEFAULT SETTING
High Alarm: -3.00 dBm
HIgh Warning: -3.50 dBm
Low Warning: -21.00 dBm
Low Alarm: -21.50 dBm
COMMAND MODE
Interface Configuration (SFP Ports)
COMMAND USAGE
◆ The threshold value is the power ratio in decibels (dB) of the measured
power referenced to one milliwatt (mW).
◆ Refer to the Command Usage section under the transceiver-threshold
current command for more information on configuring transceiver
thresholds.
◆ Trap messages enabled by the transceiver-monitor command are sent
to any management station configured by the snmp-server host
command.
EXAMPLE
The following example sets alarm thresholds for the signal power received
at port 1.
Console(config)interface ethernet 1/52
Console(config-if)#transceiver-threshold rx-power low-alarm -21
Console(config-if)#transceiver-threshold rx-power high-alarm -3
Console#
transceiver-
threshold
temperature
This command sets thresholds for the transceiver temperature which can
be used to trigger an alarm or warning message.
SYNTAX
transceiver-threshold temperature {high-alarm | high-warning
| low-alarm | low-warning} threshold-value
high-alarm – Sets the high temperature threshold for an alarm
message.
high-warning – Sets the high temperature threshold for a warning
message.
low-alarm – Sets the low temperature threshold for an alarm
message.
low-warning – Sets the low temperature threshold for a warning
message.