ECS4110-52P_Management Guide

C HAPTER 5 | Interface Configuration
Trunk Configuration
– 185 –
To configure connection parameters for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step list.
3. Select Configure from the Action list.
4. Modify the required interface settings. (See "Configuring by Port List"
on page 156 for a description of the interface settings.)
5. Click Apply.
Figure 54: Configuring Connection Settings for a Dynamic Trunk
To show connection parameters for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step list.
3. Select Show from the Action list.
Figure 55: Showing Connection Parameters for Dynamic Trunks
DISPLAYING LACP
PORT COUNTERS
Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show
Information - Counters) page to display statistics for LACP protocol
messages.
CLI REFERENCES
◆ "show lacp" on page 1030