ECS4110-52P_Management Guide

C HAPTER 4 | Basic Management Tasks
Resetting the System
– 150 –
RESETTING THE SYSTEM
Use the System > Reset menu to restart the switch immediately, at a
specified time, after a specified delay, or at a periodic interval.
CLI REFERENCES
◆ "reload (Privileged Exec)" on page 714
◆ "reload (Global Configuration)" on page 710
◆ "show reload" on page 715
COMMAND USAGE
◆ This command resets the entire system.
◆ When the system is restarted, it will always run the Power-On Self-Test.
It will also retain all configuration information stored in non-volatile
memory by the copy running-config startup-config command (see
"copy" on page 738).
PARAMETERS
The following parameters are displayed:
System Reload Information
◆ Reload Settings – Displays information on the next scheduled reload
and selected reload mode as shown in the following example:
“The switch will be rebooted at March 9 12:00:00 2012. Remaining
Time: 0 days, 2 hours, 46 minutes, 5 seconds.
Reloading switch regularly time: 12:00 everyday.”
◆ Refresh – Refreshes reload information. Changes made through the
console or to system time may need to be refreshed to display the
current settings.
◆ Cancel – Cancels the current settings shown in this field.
System Reload Configuration
◆ Reset Mode – Restarts the switch immediately or at the specified
time(s).
■
Immediately – Restarts the system immediately.
■
In – Specifies an interval after which to reload the switch.
(The specified time must be equal to or less than 24 days.)
■
hours – The number of hours, combined with the minutes,
before the switch resets. (Range: 0-576)
■
minutes – The number of minutes, combined with the hours,
before the switch resets. (Range: 0-59)