ECS4110-28T_Management Guide

C HAPTER 26 | Access Control Lists
IPv6 ACLs
– 977 –
access-list ipv6 This command adds an IP access list and enters configuration mode for
standard or extended IPv6 ACLs. Use the no form to remove the specified
ACL.
SYNTAX
[no] access-list ipv6 {standard | extended} acl-name
standard – Specifies an ACL that filters packets based on the
source IP address.
extended – Specifies an ACL that filters packets based on the
destination IP address, and other more specific criteria.
acl-name – Name of the ACL. (Maximum length: 32 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ When you create a new ACL or enter configuration mode for an existing
ACL, use the permit or deny command to add new rules to the bottom
of the list. To create an ACL, you must add at least one rule to the list.
◆ To remove a rule, use the no permit or no deny command followed by
the exact text of a previously configured rule.
◆ An ACL can contain up to 64 rules.
EXAMPLE
Console(config)#access-list ipv6 standard david
Console(config-std-ipv6-acl)#
RELATED COMMANDS
permit, deny (Standard IPv6 ACL) (978)
permit, deny (Extended IPv6 ACL) (979)
ipv6 access-group (981)
show ipv6 access-list (982)