ECS4110-28T_Management Guide

C HAPTER 24 | Authentication Commands
PPPoE Intermediate Agent
– 882 –
DEFAULT SETTING
◆ Access Node Identifier: IP address of the management interface.
◆ Generic Error Message: PPPoE Discover packet too large to process. Try
reducing the number of tags added.
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ The switch uses the access-node-identifier to generate the circuit-id for
PPPoE discovery stage packets sent to the BRAS, but does not modify
the source or destination MAC address of these PPPoE discovery
packets.
◆ These messages are forwarded to all trusted ports designated by the
pppoe intermediate-agent trust command.
EXAMPLE
Console(config)#pppoe intermediate-agent format-type access-node-identifier
billibong
Console(config)#
pppoe
intermediate-agent
port-enable
This command enables the PPPoE IA on an interface. Use the no form to
disable this feature.
SYNTAX
[no] pppoe intermediate-agent port-enable
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
PPPoE IA must also be enabled globally on the switch for this command to
take effect.
EXAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#pppoe intermediate-agent port-enable
Console(config-if)#