ECS4110-28T_Management Guide

C HAPTER 24 | Authentication Commands
802.1X Port Authentication
– 863 –
General Commands
dot1x default This command sets all configurable dot1x authenticator global and port
settings to their default values.
COMMAND MODE
Global Configuration
COMMAND USAGE
This command resets the following commands to their default settings:
◆ dot1x system-auth-control
◆ dot1x eapol-pass-through
◆ dot1x port-control
◆ dot1x port-control multi-host max-count
◆ dot1x operation-mode
◆ dot1x max-req
dot1x port-control Sets dot1x mode for a port interface IC
dot1x re-authentication Enables re-authentication for all ports IC
dot1x timeout quiet-period Sets the time that a switch port waits after the Max
Request Count has been exceeded before attempting
to acquire a new client
IC
dot1x timeout
re-authperiod
Sets the time period after which a connected client
must be re-authenticated
IC
dot1x timeout supp-timeout Sets the interval for a supplicant to respond IC
dot1x timeout tx-period Sets the time period during an authentication session
that the switch waits before re-transmitting an EAP
packet
IC
dot1x re-authenticate Forces re-authentication on specific ports PE
Supplicant Commands
dot1x identity profile Configures dot1x supplicant user name and password GC
dot1x max-start Sets the maximum number of times that a port
supplicant will send an EAP start frame to the client
IC
dot1x pae supplicant Enables dot1x supplicant mode on an interface IC
dot1x timeout auth-period Sets the time that a supplicant port waits for a
response from the authenticator
IC
dot1x timeout held-period Sets the time a port waits after the maximum start
count has been exceeded before attempting to find
another authenticator
IC
dot1x timeout start-period Sets the time that a supplicant port waits before
resending an EAPOL start frame to the authenticator
IC
Display Information Commands
show dot1x Shows all dot1x related information PE
Table 87: 802.1X Port Authentication Commands (Continued)
Command Function Mode