ECS4110-28T_Management Guide

C HAPTER 21 | System Management Commands
Line
– 756 –
timeout login
response
This command sets the interval that the system waits for a user to log into
the CLI. Use the no form to restore the default setting.
SYNTAX
timeout login response [seconds]
no timeout login response
seconds - Integer that specifies the timeout interval.
(Range: 10 - 300 seconds)
DEFAULT SETTING
300 seconds
COMMAND MODE
Line Configuration
COMMAND USAGE
◆ If a login attempt is not detected within the timeout interval, the
connection is terminated for the session.
◆ This command applies to both the local console and Telnet connections.
◆ The timeout for Telnet cannot be disabled.
◆ Using the command without specifying a timeout restores the default
setting.
EXAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#
disconnect This command terminates an SSH, Telnet, or console connection.
SYNTAX
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-8)
COMMAND MODE
Privileged Exec
COMMAND USAGE
Specifying session identifier “0” will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an SSH
or Telnet connection.