ECS4110-28T_Management Guide

C HAPTER 19 | Using the Command Line Interface
Entering Commands
– 705 –
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#
COMMAND LINE
PROCESSING
Commands are not case sensitive. You can abbreviate commands and
parameters as long as they contain enough letters to differentiate them
from any other currently available commands or parameters. You can use
the Tab key to complete partial commands, or enter a partial command
followed by the “?” character to display a list of possible matches. You can
also use the following editing keystrokes for command-line processing:
Interface interface {ethernet port |
port-channel id| vlan id}
Console(config-if) 996
Line line {console | vty} Console(config-line) 749
MSTP spanning-tree mst-configuration Console(config-mstp) 1098
Policy Map policy-map Console(config-pmap) 1211
Time Range time-range Console(config-time-range) 783
VLAN vlan database Console(config-vlan) 1155
Table 48: Configuration Command Modes (Continued)
Mode Command Prompt Page
Table 49: Keystroke Commands
Keystroke Function
Ctrl-A Shifts cursor to start of command line.
Ctrl-B Shifts cursor to the left one character.
Ctrl-C Terminates the current task and displays the command prompt.
Ctrl-E Shifts cursor to end of command line.
Ctrl-F Shifts cursor to the right one character.
Ctrl-K Deletes all characters from the cursor to the end of the line.
Ctrl-L Repeats current command line on a new line.
Ctrl-N Enters the next command line in the history buffer.
Ctrl-P Enters the last command.
Ctrl-R Repeats current command line on a new line.
Ctrl-U Deletes from the cursor to the beginning of the line.
Ctrl-W Deletes the last word typed.
Esc-B Moves the cursor back one word.
Esc-D Deletes from the cursor to the end of the word.