ECS4110-28T_Management Guide

C HAPTER 18 | General IP Routing
Address Resolution Protocol
– 689 –
Figure 413: Configuring Static ARP Entries
To display static entries in the ARP cache:
1. Click IP, ARP.
2. Select Configure Static Address from the Step List.
3. Select Show from the Action List.
Figure 414: Displaying Static ARP Entries
DISPLAYING DYNAMIC
OR
LOCAL ARP
ENTRIES
Use the IP > ARP (Show Information) page to display dynamic or local
entries in the ARP cache
. The ARP cache contains static entries, and entries
for local interfaces, including subnet, host, and broadcast addresses.
However, most entries will be dynamically learned through replies to
broadcast
messages.
CLI REFERENCES
◆ "show arp" on page 1431
WEB INTERFACE
To display all dynamic entries in the ARP cache:
1. Click IP, ARP.
2. Select Show Information from the Step List.
3. Click Dynamic Address.