ECS4110-28T_Management Guide

C HAPTER 15 | Multicast Filtering
Layer 2 IGMP (Snooping and Query for IPv4)
– 576 –
Figure 328: Showing Static Interfaces Attached a Multicast Router
To show the all interfaces attached to a multicast router:
1. Click Multicast, IGMP Snooping, Multicast Router.
2. Select Current Multicast Router from the Action list.
3. Select the VLAN for which to display this information. Ports in the
selected VLAN which are attached to a neighboring multicast router/
switch are displayed.
Figure 329: Showing Current Interfaces Attached a Multicast Router
ASSIGNING
INTERFACES TO
MULTICAST SERVICES
Use the Multicast > IGMP Snooping > IGMP Member (Add Static Member)
page to statically assign a multicast service to an interface.
Multicast filtering can be dynamically configured using IGMP Snooping and
IGMP Query messages (see "Configuring IGMP Snooping and Query
Parameters" on page 570). However, for certain applications that require
tighter control, it may be necessary to statically configure a multicast
service on the switch. First add all the ports attached to participating hosts
to a common VLAN, and then assign the multicast service to that VLAN
group.
CLI REFERENCES
◆ "ip igmp snooping vlan static" on page 1242