ECS4110-28T_Management Guide

C HAPTER 13 | Security Measures
Access Control Lists
– 372 –
WEB INTERFACE
To bind an ACL to a port:
1. Click Security, ACL.
2. Select Configure Interface from the Step list.
3. Select Configure from the Action list.
4. Select IP, MAC or IPv6 from the Type options.
5. Select a port.
6. Select the name of an ACL from the ACL list.
7. Click Apply.
Figure 197: Binding a Port to an ACL
CONFIGURING
ACL MIRRORING
After configuring ACLs, use the Security > ACL (Configure Interface – Add
Mirror) page to mirror traffic matching an ACL from one or more source
ports to a target port for real-time analysis. You can then attach a logic
analyzer or RMON probe to the target port and study the traffic crossing
the source VLAN(s) in a completely unobtrusive manner.
CLI REFERENCES
◆ "Local Port Mirroring Commands" on page 1045
COMMAND USAGE
ACL-based mirroring is only used for ingress traffic. To mirror an ACL,
follow these steps:
1. Create an ACL as described in the preceding sections.
2. Add one or more mirrored ports to ACL as described under "Binding a
Port to an Access Control List" on page 371.