ECS4110-28T_Management Guide

C HAPTER 5 | Interface Configuration
Trunk Configuration
– 189 –
WEB INTERFACE
To display LACP settings and status for the remote side:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregation Port from the Step list.
3. Select Show Information from the Action list.
4. Click Internal.
5. Select a group member from the Port list.
Figure 58: Displaying LACP Port Remote Information
CONFIGURING
LOAD BALANCING
Use the Interface > Trunk > Load Balance page to set the load-distribution
method used among ports in aggregated links.
CLI REFERENCES
◆ "port channel load-balance" on page 1022
COMMAND USAGE
◆ This command applies to all static and dynamic trunks on the switch.
◆ To ensure that the switch traffic load is distributed evenly across all
links in a trunk, select the source and destination addresses used in the
load-balance calculation to provide the best result for trunk
connections:
■
Destination IP Address: All traffic with the same destination IP
address is output on the same link in a trunk. This mode works best