ECS4110-28T_Management Guide

C HAPTER 5 | Interface Configuration
Trunk Configuration
– 182 –
more ports have the same LACP port priority, the port with the
lowest physical port number will be selected as the backup port.
■
If an LAG already exists with the maximum number of allowed port
members, and LACP is subsequently enabled on another port using
a higher priority than an existing member, the newly configured
port will replace an existing port member that has a lower priority.
N OTE : Configuring LACP settings for a port only applies to its administrative
state, not its operational state, and will only take effect the next time an
aggregate link is established with that port.
N OTE : Configuring the port partner sets the remote side of an aggregate
link; i.e., the ports on the attached device. The command attributes have
the same meaning as those used for the port actor.
WEB INTERFACE
To configure the admin key for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregator from the Step list.
3. Set the Admin Key and timeout mode for the required LACP group.
4. Click Apply.
Figure 50: Configuring the LACP Aggregator Admin Key