ECS4110-28T_Management Guide

C HAPTER 41 | LLDP Commands
– 1339 –
lldp med-tlv ext-poe This command configures an LLDP-MED-enabled port to advertise and
accept Extended Power-over-Ethernet configuration and usage information.
Use the no form to disable this feature.
SYNTAX
[no] lldp med-tlv ext-poe
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
◆ This option advertises extended Power-over-Ethernet capability details,
such as power availability from the switch, and power state of the
switch, including whether the switch is operating from primary or
backup power (the Endpoint Device could use this information to decide
to enter power conservation mode). Note that this device does not
support PoE capabilities.
◆ This command only applies to the ES4110-28P/52P.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp med-tlv ext-poe
Console(config-if)#
lldp med-tlv
inventory
This command configures an LLDP-MED-enabled port to advertise its
inventory identification details. Use the no form to disable this feature.
SYNTAX
[no] lldp med-tlv inventory
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
This option advertises device details useful for inventory management,
such as manufacturer, model, software version and other pertinent
information.