ECS4110-28T_Management Guide

C HAPTER 41 | LLDP Commands
– 1336 –
lldp dot3-tlv poe This command configures an LLDP-enabled port to advertise its Power-
over-Ethernet (PoE) capabilities. Use the no form to disable this feature.
SYNTAX
[no] lldp dot3-tlv poe
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
◆ This option advertises Power-over-Ethernet capabilities, including
whether or not PoE is supported, currently enabled, if the port pins
through which power is delivered can be controlled, the port pins
selected to deliver power, and the power class.
◆ This command only applies to the ES4110-28P/52P.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dot3-tlv poe
Console(config-if)#
lldp med-location
civic-addr
This command configures an LLDP-MED-enabled port to advertise its
location identification details. Use the no form to restore the default
settings.
SYNTAX
lldp med-location civic-addr [[country country-code] |
[what device-type] | [ca-type ca-value]]
no lldp med-location civic-addr [[country] | [what] | [ca-type]]
country-code – The two-letter ISO 3166 country code in capital
ASCII letters. (Example: DK, DE or US)
device-type – The type of device to which the location applies.
0 – Location of DHCP server.
1 – Location of network element closest to client.
2 – Location of client.
ca-type – A one-octet descriptor of the data civic address value.
(Range: 0-255)
ca-value – Description of a location. (Range: 1-32 characters)