ECS4110-28T_Management Guide

C HAPTER 40 | Multicast Filtering Commands
MVR for IPv6
– 1313 –
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
◆ A port configured as an MVR6 receiver or source port can join or leave
multicast groups configured under MVR6. A port which is not configured
as an MVR receiver or source port can use MLD snooping to join or
leave multicast groups using the standard rules for multicast filtering
(see "MLD Snooping" on page 1262).
◆ Receiver ports can belong to different VLANs, but should not be
configured as a member of the MVR VLAN. MLD snooping can be used
to allow a receiver port to dynamically join or leave multicast groups
not sourced through the MVR VLAN. Also, note that VLAN membership
for MVR receiver ports cannot be set to access mode (see the
switchport mode command).
◆ One or more interfaces may be configured as MVR source ports. A
source port is able to both receive and send data for multicast groups
which it has joined through the MVR6 protocol or which have been
assigned through the mvr6 vlan group command.
All source ports must belong to the MVR6 VLAN.
Subscribers should not be directly connected to source ports.
◆ The same port cannot be configured as a source port in one MVR
domain and as a receiver port in another domain.
EXAMPLE
The following configures one source port and several receiver ports on the
switch.
Console(config)#interface ethernet 1/5
Console(config-if)#mvr6 domain 1 type source
Console(config-if)#exit
Console(config)#interface ethernet 1/6
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#exit
Console(config)#interface ethernet 1/7
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#
mvr6 vlan group This command statically binds a multicast group to a port which will receive
long-term multicast streams associated with a stable set of hosts. Use the
no form to restore the default settings.
SYNTAX
[no] mvr6 domain domain-id vlan vlan-id group ip-address
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Receiver VLAN to which the specified multicast traffic is
flooded. (Range: 1-4094)