ECS4110-28T_Management Guide

C HAPTER 40 | Multicast Filtering Commands
MVR for IPv6
– 1305 –
EXAMPLE
The following an MVR6 group address profile to domain 1:
Console(config)#mvr6 domain 1 associated-profile rd
Console(config)#
mvr6 domain This command enables Multicast VLAN Registration (MVR) for a specific
domain. Use the no form of this command to disable MVR for a domain.
SYNTAX
[no] mvr6 domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
When MVR6 is enabled on a domain, any multicast data associated with an
MVR6 group is sent from all designated source ports, to all receiver ports
that have registered to receive data from that multicast group.
EXAMPLE
The following example enables MVR6 for domain 1:
Console(config)#mvr6 domain 1
Console(config)#
mvr6 priority This command assigns a priority to all multicast traffic in the MVR6 VLAN.
Use the no form of this command to restore the default setting.
SYNTAX
mvr6 priority priority
no mvr6 priority
priority - The CoS priority assigned to all multicast traffic forwarded
into the MVR6 VLAN. (Range: 0-7, where 7 is the highest priority)
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration