ECS4110-28T_Management Guide

C HAPTER 36 | ERPS Commands
– 1140 –
COMMAND MODE
ERPS Configuration
COMMAND USAGE
If the switch goes into ring protection state due to a signal failure, after the
failure condition is cleared, the RPL owner will start the wait-to-restore
timer and wait until it expires to verify that the ring has stabilized before
blocking the RPL and returning to the Idle (normal operating) state.
EXAMPLE
Console(config-erps)#wtr-timer 10
Console(config-erps)#
clear erps statistics This command clears statistics, including SF, NR, NR-RB, FS, MS, Event,
and Health protocol messages.
SYNTAX
clear erps statistics [domain ring-name]
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#clear erps statistics domain r&d
Console#
erps clear This command manually clears the protection state which has been
invoked by a forced switch or manual switch command, and the node is
operating under non-revertive mode; or before the WTR or WTB timer
expires when the node is operating in revertive mode.
SYNTAX
erps clear domain ring-name
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
COMMAND MODE
Privileged Exec