ECS4110-28T_Management Guide

C HAPTER 31 | Congestion Control Commands
Automatic Traffic Control Commands
– 1064 –
shutdown - If a control response is triggered, the port is
administratively disabled. A port disabled by automatic traffic
control can only be manually re-enabled.
DEFAULT SETTING
rate-control
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
◆ When the upper threshold is exceeded and the apply timer expires, a
control response will be triggered based on this command.
◆ When the control response is set to rate limiting by this command, the
rate limits are determined by the auto-traffic-control alarm-clear-
threshold command.
◆ If the control response is to limit the rate of ingress traffic, it can be
automatically terminated once the traffic rate has fallen beneath the
lower threshold and the release timer has expired.
◆ If a port has been shut down by a control response, it will not be re-
enabled by automatic traffic control. It can only be manually re-enabled
using the auto-traffic-control control-release command.
EXAMPLE
This example sets the control response for broadcast traffic on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast action shutdown
Console(config-if)#
auto-traffic-control
alarm-clear-
threshold
This command sets the lower threshold for ingress traffic beneath which a
control response for rate limiting will be released after the Release Timer
expires, if so configured by the auto-traffic-control auto-control-release
command. Use the no form to restore the default setting.
SYNTAX
auto-traffic-control {broadcast | multicast}
alarm-clear-threshold threshold
no auto-traffic-control {broadcast | multicast}
alarm-clear-threshold
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
threshold - The lower threshold for ingress traffic beneath which a
cleared storm control trap is sent. (Range: 1-255 kilo-packets per
second)