ECS4110-28T_Management Guide

C HAPTER 27 | Interface Commands
Transceiver Threshold Configuration
– 1010 –
EXAMPLE
Console(config)interface ethernet 1/52
Console(config-if)#transceiver-monitor
Console#
transceiver-
threshold-auto
This command uses default threshold settings obtained from the
transceiver to determine when an alarm or warning message should be
sent. Use the no form to disable this feature.
SYNTAX
transceiver-threshold-auto
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (SFP Ports)
EXAMPLE
Console(config)interface ethernet 1/52
Console(config-if)#transceiver-threshold-auto
Console#
transceiver-
threshold current
This command sets thresholds for transceiver current which can be used to
trigger an alarm or warning message.
SYNTAX
transceiver-threshold current {high-alarm | high-warning |
low-alarm | low-warning} threshold-value
high-alarm – Sets the high current threshold for an alarm
message.
high-warning – Sets the high current threshold for a warning
message.
low-alarm – Sets the low current threshold for an alarm message.
low-warning – Sets the low current threshold for a warning
message.
threshold-value – The threshold of the transceiver current.
(Range: 0-13100 in units of 0.01 mA)
DEFAULT SETTING
High Alarm: 100 mA
HIgh Warning: 90 mA
Low Warning: 7 mA
Low Alarm: 6 mA