ECS4110-28P_Management Guide

C HAPTER 21 | System Management Commands
Switch Clustering
– 789 –
EXAMPLE
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#
cluster member This command configures a Candidate switch as a cluster Member. Use the
no form to remove a Member switch from the cluster.
SYNTAX
cluster member mac-address mac-address id member-id
no cluster member id member-id
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch.
(Range: 1-36)
DEFAULT SETTING
No Members
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ The maximum number of cluster Members is 36.
◆ The maximum number of cluster Candidates is 100.
EXAMPLE
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
rcommand This command provides access to a cluster Member CLI for configuration.
SYNTAX
rcommand id member-id
member-id - The ID number of the Member switch.
(Range: 1-36)
COMMAND MODE
Privileged Exec
COMMAND USAGE
◆ This command only operates through a Telnet connection to the
Commander switch. Managing cluster Members using the local console
CLI on the Commander is not supported.