ECS4100 Series Web Management Guide-R07
Table Of Contents
- How to Use This Guide
- Contents
- Figures
- Tables
- Getting Started
- Web Configuration
- Using the Web Interface
- Basic Management Tasks
- Displaying System Information
- Displaying Hardware/Software Versions
- Configuring Support for Jumbo Frames
- Displaying Bridge Extension Capabilities
- Managing System Files
- Setting the System Clock
- Configuring the Console Port
- Configuring Telnet Settings
- Displaying CPU Utilization
- Configuring CPU Guard
- Displaying Memory Utilization
- Resetting the System
- Using Cloud Management
- Interface Configuration
- VLAN Configuration
- Address Table Settings
- Spanning Tree Algorithm
- Congestion Control
- Class of Service
- Quality of Service
- VoIP Traffic Configuration
- Security Measures
- AAA (Authentication, Authorization and Accounting)
- Configuring User Accounts
- Web Authentication
- Network Access (MAC Address Authentication)
- Configuring HTTPS
- Configuring the Secure Shell
- Access Control Lists
- Filtering IP Addresses for Management Access
- Configuring Port Security
- Configuring 802.1X Port Authentication
- DoS Protection
- DHCP Snooping
- DHCPv6 Snooping
- IPv4 Source Guard
- IPv6 Source Guard
- ARP Inspection
- Application Filter
- Basic Administration Protocols
- Configuring Event Logging
- Link Layer Discovery Protocol
- Power over Ethernet
- Simple Network Management Protocol
- Configuring Global Settings for SNMP
- Setting Community Access Strings
- Setting the Local Engine ID
- Specifying a Remote Engine ID
- Setting SNMPv3 Views
- Configuring SNMPv3 Groups
- Configuring Local SNMPv3 Users
- Configuring Remote SNMPv3 Users
- Specifying Trap Managers
- Creating SNMP Notification Logs
- Showing SNMP Statistics
- Remote Monitoring
- Switch Clustering
- Setting a Time Range
- Ethernet Ring Protection Switching
- Connectivity Fault Management
- Configuring Global Settings for CFM
- Configuring Interfaces for CFM
- Configuring CFM Maintenance Domains
- Configuring CFM Maintenance Associations
- Configuring Maintenance End Points
- Configuring Remote Maintenance End Points
- Transmitting Link Trace Messages
- Transmitting Loop Back Messages
- Transmitting Delay-Measure Requests
- Displaying Local MEPs
- Displaying Details for Local MEPs
- Displaying Local MIPs
- Displaying Remote MEPs
- Displaying Details for Remote MEPs
- Displaying the Link Trace Cache
- Displaying Fault Notification Settings
- Displaying Continuity Check Errors
- OAM Configuration
- UDLD Configuration
- LBD Configuration
- Smart Pair Configuration
- Multicast Filtering
- Overview
- Layer 2 IGMP (Snooping and Query for IPv4)
- Configuring IGMP Snooping and Query Parameters
- Specifying Static Interfaces for a Multicast Router
- Assigning Interfaces to Multicast Services
- Setting IGMP Snooping Status per Interface
- Filtering IGMP Packets on an Interface
- Displaying Multicast Groups Discovered by IGMP Snooping
- Displaying IGMP Snooping Statistics
- Filtering and Throttling IGMP Groups
- MLD Snooping (Snooping and Query for IPv6)
- Configuring MLD Snooping and Query Parameters
- Setting Immediate Leave Status for MLD Snooping per Interface
- Specifying Static Interfaces for an IPv6 Multicast Router
- Assigning Interfaces to IPv6 Multicast Services
- Filtering MLD Query Packets on an Interface
- Showing MLD Snooping Groups and Source List
- Displaying MLD Snooping Statistics
- Filtering and Throttling MLD Groups
- Multicast VLAN Registration for IPv4
- Multicast VLAN Registration for IPv6
- IP Tools
- IP Configuration
- General IP Routing
- Unicast Routing
- Overview
- Configuring the Routing Information Protocol
- Configuring General Protocol Settings
- Clearing Entries from the Routing Table
- Specifying Network Interfaces
- Specifying Passive Interfaces
- Specifying Static Neighbors
- Configuring Route Redistribution
- Specifying an Administrative Distance
- Configuring Network Interfaces for RIP
- Displaying RIP Interface Settings
- Displaying Peer Router Information
- Resetting RIP Statistics
- IP Services
- Appendices
Chapter 13
| Basic Administration Protocols
Simple Network Management Protocol
– 435 –
Private Traps
swPowerStatusChangeTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.1 This trap is sent when the power state changes.
swPortSecurityTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.36 This trap is sent when the port is being intruded.
This trap will only be sent when the
portSecActionTrap is enabled.
swIpFilterRejectTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.40 This trap is sent when an incorrect IP address is
rejected by the IP Filter.
swAtcBcastStormAlarmFireTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.70 When broadcast traffic is detected as a storm, this
trap is fired.
swAtcBcastStormAlarmClearTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.71 When a broadcast storm is detected as normal
traffic, this trap is fired.
swAtcBcastStormTcApplyTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.72 When ATC is activated, this trap is fired.
swAtcBcastStormTcReleaseTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.73 When ATC is released, this trap is fired.
swAtcMcastStormAlarmFireTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.74 When multicast traffic is detected as the storm, this
trap is fired.
swAtcMcastStormAlarmClearTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.75 When multicast storm is detected as normal traffic,
this trap is fired.
swAtcMcastStormTcApplyTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.76 When ATC is activated, this trap is fired.
swAtcMcastStormTcReleaseTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.77 When ATC is released, this trap is fired.
stpBpduGuardPortShutdownTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.91 This trap will be sent when an interface is shut down
because of BPDU guard.
swLoopbackDetectionTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.95 This trap is sent when loopback BPDUs have been
detected.
dot1agCfmMepUpTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.97 This trap is sent when a new remote MEP is
discovered.
dot1agCfmMepDownTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.98 This trap is sent when port status or interface status
TLV received from remote MEP indicates it is not up.
dot1agCfmConfigFailTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.99 This trap is sent when a MEP receives a CCM with
MPID which already exists on the same MA in this
switch.
dot1agCfmLoopFindTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.100 This trap is sent when a MEP receives its own CCMs.
dot1agCfmMepUnknownTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.101 This trap is sent when a CCM is received from an
unexpected MEP.
dot1agCfmMepMissingTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.102 This trap is sent when the cross-check enable timer
expires and no CCMs were received from an
expected (configured) MEP.
dot1agCfmMaUpTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.103 This trap is sent when all expected remote MEPs are
up.
autoUpgradeTrap 1.3.6.1.4.1.259.10.1.46.2.1.0.104 This trap is sent when auto upgrade is executed.
swCpuUtiRisingNotification 1.3.6.1.4.1.259.10.1.46.2.1.0.107 This notification indicates that the CPU utilization
has risen from cpuUtiFallingThreshold to
cpuUtiRisingThreshold.
Table 28: Supported Notification Messages (Continued)
Model Level Group