ECS4100 Series CLI Reference Guide-R07

Chapter 27 | Multicast Filtering Commands
MVR for IPv6
– 759 –
mvr6 vlan group This command statically binds a multicast group to a port which will receive long-
term multicast streams associated with a stable set of hosts. Use the no form to
restore the default settings.
Syntax
[no] mvr6 domain domain-id vlan vlan-id group ip-address
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Receiver VLAN to which the specified multicast traffic is flooded.
(Range: 1-4094)
group - Defines a multicast service sent to the selected port.
ip-address - Statically configures an interface to receive multicast traffic
from the IPv6 address specified for an MVR6 multicast group. This
parameter must be a full IPv6 address including the network prefix and
host address bits.
Default Setting
No receiver port is a member of any configured multicast group.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆ Multicast groups can be statically assigned to a receiver port using this
command. The assigned address must fall within the range set by the mvr6
associated-profile command.
◆ All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing
Architecture,” using 8 colon-separated 16-bit hexadecimal values. One double
colon may be used in the address to indicate the appropriate number of zeros
required to fill the undefined fields. (Note that the IP address ff02::X is reserved.)
◆ The MVR6 VLAN cannot be specified as the receiver VLAN for static bindings.
Example
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/2
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#mvr6 domain 1 vlan 2 group ff00::1
Console(config-if)#