ECS4100 Series CLI Reference Guide-R07

Chapter 1 | Initial Switch Configuration
Installing a Port License File
– 66 –
Console#copy running-config startup-config
Startup configuration file name []: startup
\Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#
To restore configuration settings from a backup server, enter the following
command:
1. From the Privileged Exec mode prompt, type “copy tftp startup-config” and
press <Enter>.
2. Enter the address of the TFTP server. Press <Enter>.
3. Enter the name of the startup file stored on the server. Press <Enter>.
4. Enter the name for the startup file on the switch. Press <Enter>.
Console#copy tftp startup-config
TFTP server IP address: 192.168.0.4
Source configuration file name: startup-rd.cfg
Startup configuration file name [startup1.cfg]:
Success.
Console#
Installing a Port License File
The switch ports are disabled by default. The ports will only function when a port
license is obtained from Edgecore and installed on the switch.
To verify whether or not a port license is installed on the switch, enter the show
interfaces brief command from the console port. If a port Status displays “License,”
then you need to obtain and install a port license for those ports. Note that a trial
license limits the number of usable ports, whereas a valid license provides full
access to all ports.
Console#show interfaces brief
Interface Name Status PVID Pri Speed/Duplex Type Trunk
--------- --------------- -------- ---- --- ------------- ------------ -----
Eth 1/ 1 Down 1 0 Auto 1000BASE-T None
Eth 1/ 2 License 1 0 Auto 1000BASE-T None
Eth 1/ 3 License 1 0 Auto 1000BASE-T None
Eth 1/ 4 License 1 0 Auto 1000BASE-T None
Eth 1/ 5 License 1 0 Auto 1000BASE-T None
Eth 1/ 6 License 1 0 Auto 1000BASE-T None
Eth 1/ 7 License 1 0 Auto 1000BASE-T None