ECS4100 Series CLI Reference Guide-R07

Chapter 4 | System Management Commands
SMTP Alerts
– 162 –
logging sendmail This command enables SMTP event handling. Use the no form to disable this
function.
Syntax
[no] logging sendmail
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#logging sendmail
Console(config)#
logging sendmail
destination-email
This command specifies the email recipients of alert messages. Use the no form to
remove a recipient.
Syntax
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you must enter a
separate command to specify each recipient.
Example
Console(config)#logging sendmail destination-email [e-mail]
Console(config)#