ECS4100 Series CLI Reference Guide-R07

Chapter 27 | Multicast Filtering Commands
MVR for IPv6
– 750 –
mvr6 associated-
profile
This command binds the MVR6 group addresses specified in a profile to an MVR6
domain. Use the no form of this command to remove the binding.
Syntax
[no] mvr6 domain domain-id associated-profile profile-name
domain-id - An independent multicast domain. (Range: 1-5)
profile-name - The name of a profile containing one or more MVR6 group
addresses. (Range: 1-21 characters)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
MVR6 domains can be associated with more than one MVR6 profile. But since MVR6
domains cannot share the group range, an MVR6 profile can only be associated
with one MVR6 domain.
Example
The following an MVR6 group address profile to domain 1:
Console(config)#mvr6 domain 1 associated-profile rd
Console(config)#
mvr6 domain This command enables Multicast VLAN Registration for IPv6 (MVR6) for a specific
domain. Use the no form of this command to disable MVR6 for a domain.
Syntax
[no] mvr6 domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
When MVR6 is enabled on a domain, any multicast data associated with an MVR6
group is sent from all designated source ports, to all receiver ports that have
registered to receive data from that multicast group.