ECS4100 Series CLI Reference Guide-R07

Chapter 16 | Loopback Detection Commands
– 490 –
Example
Console#loopback-detection release
Console#
show loopback-
detection
This command shows loopback detection configuration settings for the switch or
for a specified interface.
Syntax
show loopback-detection [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/26/28/52)
port-channel
channel no. Port-channel interface number
(Range 1-16)
Command Mode
Privileged Exec
Command Usage
Although global action may be set to None, this command will still display the
configured Detection Port Admin State and Information Oper State.
Example
Console#show loopback-detection
Loopback Detection Global Information
Global Status : Enabled
Transmit Interval : 10
Recover Time : 60
Action : Shutdown
Trap : None
Loopback Detection Port Information
Port Admin State Oper State
-------- ----------- ----------
Eth 1/ 1 Enabled Normal
Eth 1/ 2 Disabled Normal
Eth 1/ 3 Disabled Normal
.
.
.
Console#show loopback-detection ethernet 1/1
Loopback Detection Information of Eth 1/1
Admin State : Enabled
Oper State : Normal
Looped VLAN : None
Console#