ECS4100 Series CLI Reference Guide-R07

Chapter 11 | Interface Commands
Interface Configuration
– 418 –
00d 01:45:00 0 0
00d 02:00:00 0 0
00d 02:15:00 0 0
00d 02:30:00 0 0
00d 02:45:00 0 0
00d 03:00:00 0 0
00d 03:15:00 0 0
00d 03:30:00 0 0
00d 03:45:00 0 0
00d 04:00:00 0 0
Console#
show interfaces status This command displays the status for an interface.
Syntax
show interfaces status [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/26/28/52)
port-channel channel-id (Range: 1-16)
vlan vlan-id (Range: 1-4094)
Default Setting
Shows the status for all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
Console#show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Port Type : 1000BASE-T
MAC Address : 00-E0-0C-00-00-FE
Configuration:
Name :
Port Admin : Up
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full, 1000full
Broadcast Storm : Enabled
Broadcast Storm Limit : 500 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 500 packets/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 500 packets/second