ECS4100 Series CLI Reference Guide-R07

Chapter 29 | CFM Commands
Fault Generator Operations
– 835 –
Fault Generator Operations
mep fault-notify
alarm-time
This command sets the time a defect must exist before a fault alarm is issued. Use
the no form to restore the default setting.
Syntax
mep fault-notify alarm-time alarm-time
no fault-notify alarm-time
alarm-time – The time that one or more defects must be present before a
fault alarm is generated. (Range: 3-10 seconds)
Default Setting
3 seconds
Command Mode
CFM Domain Configuration
Command Usage
A fault alarm is issued when the MEP fault notification generator state machine
detects that a time period configured by this command has passed with one or
more defects indicated, and fault alarms are enabled at or above the priority level
set by the mep fault-notify lowest-priority command.
Example
This example set the delay time before generating a fault alarm.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#mep fault-notify alarm-time 10
Console(config-ether-cfm)#
mep fault-notify
lowest-priority
This command sets the lowest priority defect that is allowed to generate a fault
alarm. Use the no form to restore the default setting.
Syntax
mep fault-notify lowest-priority priority
no fault-notify lowest-priority
priority – Lowest priority default allowed to generate a fault alarm.
(Range: 1-6)
Default Setting
Priority level 2
Command Mode
CFM Domain Configuration