ECS4100 Series CLI Reference Guide-R07

Chapter 28 | LLDP Commands
– 793 –
show lldp config This command shows LLDP configuration settings for all ports.
Syntax
show lldp config [detail interface]
detail - Shows configuration summary.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/26/28/52)
port-channel channel-id (Range: 1-16)
Command Mode
Privileged Exec
Example
The following example shows the basic LLDP parameters for Port 1.
Console#show lldp config detail ethernet 1/1
LLDP Port Configuration Detail
Port : Eth 1/1
Admin Status : Tx-Rx
Notification Enabled : True
Basic TLVs Advertised : port-description
system-name
system-description
system-capabilities
management-ip-address
802.1 specific TLVs Advertised : port-vid
vlan-name
proto-vlan
proto-ident
802.3 specific TLVs Advertised : mac-phy
link-agg
max-frame
MED Notification Status : Disabled
MED Enabled TLVs Advertised : med-cap
network-policy
location
inventory
MED Location Identification
Location Data Format : Civic Address LCI
Country Name : DK
What : 2 - DHCP Client
CA Type 1 : 12
CA Type 13 : 13
Console#