ECS4100 Series CLI Reference Guide-R07

Chapter 27 | Multicast Filtering Commands
MVR for IPv6
– 763 –
Example
The following displays information about the interfaces attached to the MVR6
VLAN in domain 1:
Console#show mvr6 domain 1 interface
MVR6 Domain : 1
Port Type Status Immediate Leave Static Group Address
-------- -------- ------------------- ---------------- ----------------
Eth1/ 1 Source Active/Forwarding
Eth1/ 2 Receiver Active/Forwarding Disabled ff00::1(VLAN1)
Console#
show mvr6 members This command shows information about the current number of entries in the
forwarding database, or detailed information about a specific multicast address.
show mvr6 members { [ip-address]| host-ip-address [ip-address | ds-vlan vlan-id
[ip-address | interface ip-address] | interface ip-address ] | mld | sort-by-port [ip-
address | ds-vlan vlan-id [ip-address | interface ip-address] | interface ip-address ] |
unknown]}
ip-address - IPv6 address for an MVR6 multicast group.
host-ip-address - Show entries by subscriber IPv6 address
mld - Show entries created by MLD protocol.
sort-by-port - Show entries with groups sorted by port.
unknown - Show entries created by receiving multicast streams.
user - Show user configured entries.
ds-vlan - Downstream VLAN ID (Range: 1-4094)
interface
Table 154: show mvr6 interface - display description
Field Description
Port Shows interfaces attached to the MVR6.
Type Shows the MVR6 port type.
Status Shows the MVR6 status and interface status. MVR6 status for source ports is
“ACTIVE” if MVR6 is globally enabled on the switch. MVR6 status for receiver
ports is “ACTIVE” only if there are subscribers receiving multicast traffic from
one of the MVR6 groups, or a multicast group has been statically assigned to
an interface.
Immediate Leave Shows if immediate leave is enabled or disabled.
Static Group Address Shows any static MVR6 group assigned to an interface, and the receiver
VLAN.