ECS4100 Series CLI Reference Guide-R07

Chapter 27 | Multicast Filtering Commands
MVR for IPv6
– 761 –
show mvr6 This command shows information about MVR6 domain settings, including MVR6
operational status, the multicast VLAN, the current number of group addresses, and
the upstream source IP address.
Syntax
show mvr6 [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays configuration settings for all MVR6 domains.
Command Mode
Privileged Exec
Example
The following shows the MVR6 settings:
Console#show mvr6
MVR6 Proxy Switching : Enabled
MVR6 Robustness Value : 1
MVR6 Proxy Query Interval : 125(sec.)
MVR6 Source Port Mode : Always Forward
Domain : 1
MVR6 Config Status : Enabled
MVR6 Running Status : Active
MVR6 Multicast VLAN : 1
MVR6 Current Learned Groups : 0
MVR6 Upstream Source IP : FF05::25
Console#
Table 153: show mvr6 - display description
Field Description
MVR6 Proxy Switching Shows if MVR6 proxy switching is enabled
MVR6 Robustness Value Shows the number of reports or query messages sent when proxy
switching is enabled
MVR6 Proxy Query
Interval
The interval at which the receiver port sends out general queries
MVR6 Source Port Mode Shows if the switch only forwards multicast streams which the source port
has dynamically joined or always forwards multicast streams
Domain An independent multicast domain.
MVR6 Config Status Shows if MVR6 is globally enabled on the switch.
MVR6 Running Status Indicates whether or not all necessary conditions in the MVR6
environment are satisfied. (Running status is true as long as MVR6 Status is
enabled, and the specified MVR6 VLAN exists, and a source port with a
valid link has been configured (using the mvr6 type command.)
MVR6 Multicast VLAN Shows the VLAN used to transport all MVR6 multicast traffic.