ECS4100 Series CLI Reference Guide-R07

Chapter 10 | Access Control Lists
IPv6 ACLs
– 388 –
This allows packets to any destination address when the DSCP value is 5.
Console(config-ext-ipv6-acl)#permit any any dscp 5
Console(config-ext-ipv6-acl)#
This allows any packets sent from any source to any destination when the next
header is 43.”
Console(config-ext-ipv6-acl)#permit any any next-header 43
Console(config-ext-ipv6-acl)#
Related Commands
access-list ipv6 (384)
Time Range (180)
ipv6 access-group This command binds an IPv6 ACL to a port. Use the no form to remove the port.
Syntax
ipv6 access-group acl-name {in |
out}
[time-range time-range-name] [counter]
no ipv6 access-group acl-name {in |
out}
acl-name – Name of the ACL. (Maximum length: 32 characters)
in – Indicates that this list applies to ingress packets.
out – Indicates that this list applies to egress packets.
time-range-name - Name of the time range. (Range: 1-32 characters)
counter – Enables counter for ACL statistics.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
If a port is already bound to an ACL and you bind it to a different ACL, the switch
will replace the old binding with the new one.
Example
Console(config)#interface ethernet 1/2
Console(config-if)#ipv6 access-group standard david in
Console(config-if)#