ECS4100 Series CLI Reference Guide-R07

Chapter 5 | SNMP Commands
Additional Trap Commands
– 213 –
trap - If traps are enabled, the switch will send an alarm message if CPU
utilization exceeds the high watermark in percentage of CPU usage time or
exceeds the maximum threshold in the number of packets being processed
by the CPU.
Default Setting
Guard Status: Disabled
High Watermark: 90%
Low Watermark: 70%
Maximum Threshold: 500 packets per second
Minimum Threshold: 50 packets per second
Trap Status: Disabled
Command Mode
Global Configuration
Command Usage
◆ Once the high watermark is exceeded, utilization must drop beneath the low
watermark before the alarm is terminated, and then exceed the high
watermark again before another alarm is triggered.
◆ Once the maximum threshold is exceeded, utilization must drop beneath the
minimum threshold before the alarm is terminated, and then exceed the
maximum threshold again before another alarm is triggered.
Example
Console(config)#process cpu guard high-watermark 80
Console(config)#process cpu guard low-watermark 60
Console(config)#
Related Commands
show process cpu guard (120)