ECS4100 Series CLI Reference Guide-R07

Chapter 29 | CFM Commands
Fault Generator Operations
– 837 –
Example
This example sets the lowest priority defect that will generate a fault alarm.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#mep fault-notify lowest-priority 1
Console(config-ether-cfm)#
mep fault-notify
reset-time
This command configures the time after a fault alarm has been issued, and no
defect exists, before another fault alarm can be issued. Use the no form to restore
the default setting.
Syntax
mep fault-notify reset-time reset-time
no fault-notify reset-time
reset-time – The time that must pass without any further defects indicated
before another fault alarm can be generated. (Range: 3-10 seconds)
Default Setting
10 seconds
Command Mode
CFM Domain Configuration
Example
This example sets the reset time after which another fault alarm can be generated.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#mep fault-notify reset-time 7
Console(config-ether-cfm)#
show ethernet cfm
fault-notify-generator
This command displays configuration settings for the fault notification generator.
Syntax
show ethernet cfm fault-notify-generator mep mpid
mpid – Maintenance end point identifier. (Range: 1-8191)
Default Setting
None
Command Mode
Privileged Exec