ECS4100 Series CLI Reference Guide-R07

Chapter 28 | LLDP Commands
– 795 –
show lldp info
remote-device
This command shows LLDP global and interface-specific configuration settings for
remote devices attached to an LLDP-enabled port.
Syntax
show lldp info remote-device [detail interface]
detail - Shows detailed information.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/26/28/52)
port-channel channel-id (Range: 1-16)
Command Mode
Privileged Exec
Example
Note that an IP phone or other end-node device which advertises LLDP-MED
capabilities must be connected to the switch for information to be displayed in the
“LLDP-MED Capability” and other related fields.
Console#show lldp info remote-device
LLDP Remote Devices Information
Local Port Chassis ID Port ID System Name
---------- ----------------- ----------------- ----------------------------
Eth 1/1 00-E0-0C-00-00-FD 00-E0-0C-00-01-02
Console#show lldp info remote-device detail ethernet 1/1
LLDP Remote Devices Information Detail
---------------------------------------------------------------
Index : 2
Chassis Type : MAC Address
Chassis ID : 70-72-CF-91-1C-B2
Port ID Type : MAC Address
Port ID : 70-72-CF-91-1C-B4
Time To Live : 120 seconds
Port Description : Ethernet Port on unit 1, port 2
System Description : ECS4510-28T
System Capabilities : Bridge
Enabled Capabilities : Bridge
Management Address : 192.168.0.4 (IPv4)
Port VLAN ID : 1
Port and Protocol VLAN ID : supported, disabled
VLAN Name : VLAN 1 - DefaultVlan
Protocol Identity (Hex) : 88-CC
MAC/PHY Configuration/Status
Port Auto-neg Supported : Yes
Port Auto-neg Enabled : Yes
Port Auto-neg Advertised Cap (Hex) : 6C00