ECS4100 Series CLI Reference Guide-R07

Chapter 27 | Multicast Filtering Commands
MLD Filtering and Throttling
– 720 –
Example
Console(config)#ipv6 mld profile 19
Console(config-mld-profile)#permit
Console(config-mld-profile)#
range This command specifies multicast group addresses for a profile. Use the no form to
delete addresses from a profile.
Syntax
[no] range low-ipv6-address high-ipv6-address
low-ipv6-address - A valid IPv6 address (X:X:X:X::X) of a multicast group or
start of a group range.
high-ipv6-address - A valid IPv6 address (X:X:X:X::X) for the end of a
multicast group range.
Default Setting
None
Command Mode
MLD Profile Configuration
Command Usage
Enter this command multiple times to specify more than one multicast address or
address range for a profile.
Example
Console(config-mld-profile)#range ff01::0101 ff01::0202
Console(config-mld-profile)#
ipv6 mld filter
(Interface Configuration)
This command assigns an MLD filtering profile to an interface on the switch. Use
the no form to remove a profile from an interface.
Syntax
ipv6 mld filter profile-number
no ipv6 mld filter
profile-number - An MLD filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)